![]() ![]() ![]() All readings should be approximately 6 ohms. Remove the connector plug and check across pins 1 to 2, 2 to 3, and 1 to 3. Perform a continuity check of the Drive Motor windings. Once the screws are removed, the top panel will slide back, then lift off. This is accomplished by removing the three screws in the back of the washer that hold the top in place. You will need to remove the top panel to access the CCU. NOTE: The CCU is the main computer for the washer and is located behind the wash tub. To access the MCU, you will need to remove the back panel of the washer. NOTE: The MCU is a circuit board located in the vicinity of the Drive Motor on the bottom rear of the washer. Verify all connections between the Drive Motor, Motor Control Unit (MCU), and Central Control Unit (CCU). The error is an indication a motor speed problem.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |